Cognitive TPG A799 Guía de usuario descargar pdf (Pagina 12)

Chapter 3: Setting up the Printer12

A799 Two-Color Thermal Receipt Printer: User Guide A799-UG00001 Rev. C 12/08

Load or change the receipt paper

Caution: You must use qualied paper rolls with TPG printers. The list of qualied paper is in Chapter 5. Using

unqualied paper may void the warranty.

You will later use the same procedure to change the receipt paper as you will to load it during installation. The minor

difference is noted in the directions below.

If you are installing the printer using the wall mount kit, you may nd it easier to load the paper roll after installation.

Note: The printer must be set to the paper type being used for proper operation. This can be done by sending the command

1D 81 m n or by a selection in the conguration menu. To change the paper type in the conguration main menu select

“Set Paper Type” and make selections. (See page 21 for how to enter the conguration menu.)

1 Open the receipt cover by pushing up evenly on each side of the cover until it unsnaps (1).

2 Loading: Remove the test printout (2) and starter roll. Slide the supports off the roll (3).

Changing: Remove the used paper roll.

3 Tear a clean edge on the new receipt paper roll, making sure the tape has been completely removed.

4 Place the receipt paper into the paper compartment so it unrolls from the bottom (4). Leave a few inches of paper

sticking out of the printer.

5 While holding the paper in place, close the receipt cover (5). To test that the paper is loaded correctly, advance the

paper with the paper feed button.

Note: If the paper jams, make sure the roll is inserted correctly. Check the illustration above for proper orientation.

6 Tear the excess paper off against the blade in the cover (6).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sin comentarios

Cognitive TPG A799 Guía de usuario Pagina 12