Cognitive TPG A799 Guía de usuario descargar pdf (Pagina 18)

Chapter 3: Setting up the Printer18

A799 Two-Color Thermal Receipt Printer: User Guide A799-UG00001 Rev. C 12/08

Power supply cable

To avoid damaging the printer, connect the power supply last.

1 Plug the power cable into the power connector located in the center of the illustration.

2 Close the connector cover until it snaps, making sure that all the cables are aligned with the slots in the connector cover.

Double-check that the strain relief on the connector cover is aligned with the power supply cable (see “Cable routing”

section which follows).

3 Plug the power cord into the power supply.

4 Plug the power supply into a grounded outlet. When it is properly powered, the green LED on the top of the printer will

light up.

WARNING! Using this device without a grounded outlet is a safety hazard and voids the printer Warranty, Safety, FCC

and CE Mark designation.

Ethernet communication cable

Ethernet communication connector panel

Ethernet

connector

Power

supply

connector

1 You don’t need to turn off the computer. Plug the printer end of the Ethernet cable into the Ethernet connector port on

the printer (A). Make sure the connector snaps rmly in place.

2 Plug the computer end of the Ethernet cable into the Ethernet port of the computer. Make sure the connector snaps

rmly in place.

3 After you have connected the printer, you may need to set the printer internal parameters for Ethernet operation. See

Ethernet Setup Guide.

Power

Supply

Connector

Connector Interface Panel

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sin comentarios

Cognitive TPG A799 Guía de usuario Pagina 18