Cognitive TPG A799 Guía de usuario descargar pdf (Pagina 19)

Chapter 3: Setting up the Printer 19

12/08 A799-UG00001 Rev. C A799 Two-Color Thermal Receipt Printer: User Guide

Test the printer

If the printer is functioning normally, it will beep once. If it responds differently, look in Chapter 4: Using the Printer,

“Troubleshooting the printer” (page 26) or contact TPG for technical support.

The printer will arrive for installation pre-congured. The printer’s current conguration appears on the test (diagnostics)

printout. However, if you would like to run a new print test or check the congurations, you can run a diagnostics printout

detailing the current conguration.

To run a diagnostic test:

1 Make sure paper is in the printer (1).

2 Open the receipt cover (2).

3 Press and hold the paper feed button (3).

4 Close the receipt cover, continually holding the paper

feed button until the conguration printout begins (4).

For further instructions, see Chapter 4: Using the printer,

“Conguring the printer” (page 20).

For USB printers only:

Guide the USB cable through the strain relief and out the slot in the connector cover, as shown in the illustration. The

USB cable ts underneath the power supply and cash drawer cables. The RS-232C cable routes straight out the back when

attached.

Cable routing

To prevent the printer from becoming unplugged accidentally, make sure the cables are routed as shown in the illustration

below.

Receipt Cover

Paper Feed Button



1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Sin comentarios

Cognitive TPG A799 Guía de usuario Pagina 19